汽車車燈冷膠機工作原理以及工作流程
汽車車燈冷膠機是汽車修理廠、汽配店、美容店等用來修補汽車前大燈的專用設備。它具有操作簡單、方便,使用靈活等優點,深受廣大用戶的喜愛。下面就由廠家來給大家講解一下相關事項吧!
Automobile lamp cold glue machine is a special equipment used to repair automobile headlights in automobile repair shop, auto parts shop, beauty shop, etc. It has the advantages of simple operation, convenience and flexible use, and is deeply loved by the majority of users. Now let's let the manufacturer explain the relevant matters to you!
工作原理:
working principle:
膠水在壓力的作用下通過針頭噴出并固化在燈殼內壁與玻璃之間的縫隙中。由泵體(含電機)、膠管及針筒三部分組成。
Glue is sprayed through a needle under pressure and solidified in the gap between the inner wall of the lamp housing and the glass. It is composed of pump body (including motor), rubber hose and needle cylinder.
工作流程:
Workflow:
(1)打開電源開關。
(1) Turn on the power switch.
(2)將膠水倒入泵體的貯料桶內。
(2) Pour the glue into the storage bucket of the pump body.
(3)啟動機器使電機運轉帶動齒輪減速器轉動。
(3) Start the machine to make the motor run and drive the gear reducer to rotate.
(4)當齒輪減速器的轉速達到設定值時。
(4) When the speed of the gear reducer reaches the set value.
(5)按動啟動按鈕。
(5) Press the start button.
(6)開始灌膠。
(6) Start filling glue.
(7)待到一定時間后。
(7) After a certain time.
(8)停止灌注。
(8) Stop perfusion.
此外在使用前建議您檢查各部件連接緊固件是否松動;檢查電器元件是否正常;檢查電路有無漏電現象。等等,為了著想,要做好相應的事項,關注我們
http://www.cztaiyue.com了解更多!
In addition, it is recommended that you check whether the connecting fasteners of each component are loose before use; Check whether electrical components are normal; Check the circuit for leakage. Wait, for the sake of safety, we should do a good job and pay attention to us http://www.cztaiyue.com Learn more!
上一篇:雙組份打膠機流速慢或直接打不出膠來的原因
下一篇:全自動邊框機的4種常見故障